MG3 Will not load in Logic Pro X

Just purchased MG3 but get this message when trying to load onto an audio track in Logic Pro. I followed the instructions as shown.

"Your DAW isn’t sending any audio to MIDI GUITAR. Enable the guitar input / monitoring for the track.”
Please advise

Assuming the audio track has an audio input and your track is armed, close and reopen the plugin GUI. Does that help?

I was just using MG3 in Logic Pro earlier today. It definitely works.

Maybe just clarify one point: Did you mean that you purchased the hex tracker? The hex version of the MG3 audio unit has some issues with Logic due to sandboxing. If this is what you actually meant, you’ll need to use MG3 in standalone for now or reach out to Jam Origin to see if a new beta version of the AUv3 is available.

This message occur if MG doesn’t get any audio from Logic. It can also happen if Logic sends very large buffers (which are no good for real time use). So, please make sure Logic or your interface is set to small buffers (128 or 256 @ 44.1/48Khz).
Logic will often use very large buffers regardless of your setting, when it’s not doing anything. So try to press play, and it should work.
Obviously you should also have the audio input (I) enabled on the track.

A very light project file here, but loads up with zero issues.