Samplemodeling bug / Request to support GUI-less plugins

There are a lot of small issues I come across, not critical but I guess I should start reporting them.

1- I create a patch with MG3 plugin in Windows, inside the MG3 I use Kontakt, inside Kontakt I load Samplemodeling “The Trumpet 3”, Inside “The Trumpet V3” I set the MUTE to HARMON, I save everything but next time I recall the preset the MUTE state reverts to the default NO MUTE state. (I will investigate this further maybe MG3 is not to blame here)

2- I can not use plugins (like Airwindows) that do not have a GUI. In a DAW a basic panel of controls would pop up to allow you to control the parameters but in MG3 nothing shows up.

Are you not familiar with Airwindows? Do yourself a favor and try “To TAPE 8” plugin, it’s a free tape saturation plugin that’s unbelievable. Thank me later!

:slightly_smiling_face:

1 Like

Hi @ElectroFuzz

That Mute/Harmon bug has been an issue for some time so here is a workaround if you use it a lot:

  1. Go into CC remapping 2
  2. In mute you change the default value from 100 to 81

Then you save the Kontakt instrument from: FILE/Save as.

I called mine Trumpet v3 Harm Mute (as you can see)
This patch will appear in the Trumpet v3 Instruments

Skärmavbild 2025-01-19 kl. 22.57.30

Choose that for that patch in MG3 and save it. Hopefully it will work for you as well.
:+1:

Thanks for confirming this.
I did the workaround and it worked.
I had a feeling it wasn’t an MG3 issue.

1 Like