Would it be practical if MG3 had a little harmoniser that could do the following:
-
when a single note is played: Optionally select the third and/or the fifth/second/seventh/octave within a scale
-
optionally ‘bloom’ the chord step by step with midi controller/internal control (e.g. bending, strike)
-
optionally add a new audio or MIDI sound for each pitch using the controller (as described under 2.), e.g. a brass section: root note trombone, the third a horn, the fifth a trumpet or a saxophone etc.
-
if more than one note is played at the same time, extend the chords accordingly with other instruments (e.g. doubling the fifth or octave) or other chord notes e.g. +9 or +11?
Especially if bass is played (on the lower strings), higher strings could simultaneously provide chord interjections, important for small bands, e.g. trio guitar, bass and drums, the bass takes over the rhythm section, for example, when the guitar plays a solo